Home / HVAC / Santa Fe / Furnace repair

Furnace repair in Santa Fe

When a Santa Fe furnace stops heating, check the thermostat, the furnace switch and breaker, and the filter, then call a licensed HVAC contractor. Santa Fe homes can mix forced air with other systems, so confirm what you actually have before you book. If a repair turns into a replacement, the City of Santa Fe requires a permit for new and replacement mechanical equipment.

By Enchanted Pros · Updated November 12, 2026

Get quotes for this job

What should I check first when my Santa Fe furnace stops heating?

Check the thermostat mode and batteries, the furnace power switch and breaker, and the filter. Then call a licensed contractor if it still will not run.

  1. Set the thermostat to Heat well above room temperature.
  2. Check the switch at the furnace and the breaker.
  3. Replace a clogged filter and open all vents.
  4. If you use propane, check the tank gauge before assuming the furnace has failed. Do not relight a pilot you do not know how to light.
  5. If you smell gas, leave the home and call 911 or your gas supplier from outside.

Do I have a furnace, a boiler, or something else?

Forced-air furnaces move warm air through ducts and registers. Boilers heat water that runs through radiators or radiant floors. Some older and adobe homes use a boiler, a wall unit, or a mini-split instead.

If you have radiators, baseboard, or in-floor tubing, read our boiler and radiant heat guide for Santa Fe. The contractor you hire should be licensed for the system you have.

Does it matter if my home uses propane?

Yes, ask about it. New Mexico's MM-2 classification covers natural gas fitting and warm-air appliances but states that it may not install LP gas systems.

That means propane work can involve a different license scope. Ask any contractor which classification covers the tank, piping, and appliance work on your property, and ask them to show their license in the NM CID lookup.

Do I need a permit to replace a furnace in Santa Fe?

Probably, if the equipment is replaced. The City of Santa Fe lists new and replacement mechanical equipment among work that requires a permit.

Stand-alone mechanical permits are available through the City's online permitting portal. If your home is in a historic district, exterior changes such as a new vent or condenser location need Historic Preservation Division approval before a construction permit, so tell your contractor early. See the City's historic preservation page.

What should a furnace repair quote include?

The diagnosed fault, itemized parts and labor, any diagnostic fee, and written warranty terms.

  • The failed part or condition named in writing.
  • Parts, labor, and trip fee itemized.
  • Warranty on parts and labor.
  • The contractor's NM license classification.
  • A written explanation if replacement is recommended, so you can get a second opinion.

Related guides

Frequently asked questions

Do I need a permit to replace a furnace in Santa Fe?

The City of Santa Fe requires permits for new and replacement mechanical equipment. Ask your contractor who will pull it, and confirm with the City if you are unsure.

Is propane work licensed differently in New Mexico?

New Mexico's MM-2 natural gas fitting classification states that it may not install LP gas systems, so ask contractors which license covers propane work on your home.

How often should a furnace be inspected?

CPSC advises a professional inspection of all fuel-burning heating systems every year, along with carbon monoxide alarms on each level and outside sleeping areas.

How much does furnace repair cost in Santa Fe?

We do not publish prices because we found no neutral public source for local costs. Request itemized written estimates from more than one licensed contractor.

Sources

Facts were checked against these sources on November 12, 2026. Rules, fees, and phone numbers change, so confirm with the agency before you act. We do not publish prices.

Enchanted Pros is a directory, not a contractor. We do not dispatch crews, and nothing here is a ranking or endorsement. Verify any New Mexico contractor license with the Construction Industries Division lookup before you hire.

Get quotes

Get free HVAC quotes in Santa Fe

One short form. We share it with up to three local pros so they can call you with a quote. Free, no obligation.

By clicking “Request quotes,” you agree that Enchanted Pros and up to three local contractors we share your request with may contact you about this request by phone call, text message, or email at the number and email you provide, including calls and texts sent using automated technology. Consent is not a condition of any purchase or service. Message and data rates may apply; reply STOP to opt out of texts. See our privacy page.

Local contractors

These names come from public sources. Ratings are as cited and may change — re-verify them. Always check a New Mexico CID license before you hire. This is not a ranking or endorsement.

  • Pro-Tech Air Conditioning & Heating

    HVAC · Santa Fe

    3933 San Felipe Rd, Santa Fe, NM 87507

    Get quotes

    4.9 (601 reviews) — as cited, re-verify

    Verify license status yourself. Look up a CID license.

  • Roadrunner Air Conditioning Heating & Plumbing

    HVAC · Santa Fe

    27482 E Frontage Rd, Santa Fe, NM 87508

    Get quotes

    A public Google rating was not recorded for this listing.

    Verify license status yourself. Look up a CID license.

Get free quotes